In Dickinson, AC and duct mold typically grows on the coil, in a pan that holds water, on ducts that sweat and on supply grilles, and in some homes it traces back to Harvey floodwater. Removal means fixing the moisture source and cleaning or replacing contaminated components under a Texas protocol. Call the number on this page to be connected with a local mold remediation company in Dickinson.

Signs of mold in the system
- Speckled or fuzzy growth on supply registers and the ceiling beside them
- A musty or sour smell carried by the airflow
- Rust, slime or standing water in the pan under the coil
- A ceiling stain below an attic air handler
- Low returns or duct boots with silt lines or water marks
- Humidity indoors that stays high after hours of cooling
Local conditions in Dickinson
Dickinson is a Galveston County city about 32 miles from Houston, with Dickinson Bayou flowing in and out of town. During Harvey, about 90 percent of the city flooded and about half was destroyed by flooding. Homes rebuilt after that may have new ductwork, but some kept air handlers or duct runs that took water and were dried and reused. EPA's disaster guide says to assume mold where materials could not be dried within 24 to 48 hours, and duct liners and insulation hold water well. Beyond flood history, the usual suspects apply: a long cooling season, coils that stay wet for months, condensate lines that clog, and attic ducts that sweat when their insulation tears.

What affects cost
National ranges (HomeGuide, 2026) put mold work on an HVAC system or ducts at $2,000 to $10,000, and Angi's Houston cost data reports general mold removal averaging $2,016. A Dickinson job moves within that range based on how much duct is replaced, whether equipment from the flood era has to go, attic access and HVAC repairs to pans and drains. The assessor who writes the protocol and checks clearance is a separate company under Texas law, so that fee is in addition.
What happens when you call
You're connected with an independent local company. A mold assessment consultant who holds a TDLR license inspects and writes a protocol, a different company performs the removal, and the consultant confirms clearance before you receive a Certificate of Mold Damage Remediation. Replacement ducts or equipment may need a permit from the City of Dickinson's Building Permits & Inspections Division, whose page also posts the FEMA Elevation Certificate form. Renters with unrepaired leaks can use the city's online Report a Code Violation form. The Galveston County Health District does not handle mold.
AC & Air Duct Mold Removal questions in Dickinson
Our ducts took floodwater. Can they be saved?
Can flexible duct be cleaned, or does it have to go?
My rental's AC smells musty. What can I do in Dickinson?
Will the Galveston County Health District check my AC for mold?
More mold services in Dickinson
AC & Air Duct Mold Removal nearby
Helpful guides
Sources
- EPA: Homeowner's and Renter's Guide to Mold Cleanup After Disasters (pdf)
- EPA: Mold Cleanup in Your Home
- TDLR: Mold Assessors and Remediators FAQs
- 16 Tex. Admin. Code 78.150: Photographs; Certificate of Mold Damage Remediation; Duty of Property Owner
- HomeGuide: How Much Does Mold Removal and Remediation Cost? (2026)
- Angi: How much do mold removal services typically cost? (Houston, TX)
- Tex. Prop. Code 92.052: Landlord's Duty to Repair or Remedy
- TexasLawHelp: Mold and Renter's Rights in Texas
- Galveston County Health District: File a Public Health Complaint
- Wikipedia: Dickinson, Texas
- City of Dickinson: Building Permits & Inspections
Last updated: