Wall mold in Tomball usually follows water that got into the cavity from creek or stormwater flooding, a plumbing leak or an attic AC drain. It is handled by stopping the water, removing the wet drywall and insulation, and cleaning and drying the studs. Call the number on this page to be connected with a local mold remediation company in Tomball.
A quick look at Tomball
Tomball is a small city of about 12,300 in northwest Harris County, around 24 miles from downtown Houston, that grew around the railroad and sits on SH 249 and FM 2920. It lies in the Spring Creek and Willow Creek watersheds. The Harris County Flood Control District listed Tomball among communities affected in the 2016 Tax Day flood, and in Hurricane Harvey water rose into homes near Spring, Willow, Mill and Walnut creeks, with about 15 water rescues. The city's floodplain office stresses that FEMA maps are estimates and that homes outside the 100-year floodplain can still flood, often from local stormwater ponding.
What to do now
- Locate the source. Ponding against an exterior wall, a plumbing run or the AC closet are the usual suspects.
- Stop the water. Regrade or redirect drainage outside, fix the leak inside.
- Start drying. EPA's guidance is to dry wet materials within 24 to 48 hours.
- Leave the drywall alone. Cutting it open without containment spreads dust and spores.
- Get an assessment for anything hidden or large. A mold assessment consultant who holds a TDLR license writes the protocol, and a separate company removes the mold.
- Apply for the rebuild permit. The City of Tomball Building Division issues building permits through its online SmartGov portal.
Signs and their usual causes
| What you see | Likely cause |
|---|---|
| Stain at the base of an exterior wall after storms | Stormwater ponding against the slab |
| Damp drywall below a second-floor bathroom | Leaking tub, toilet seal or supply line |
| Musty interior wall near the hall return | Air handler drain pan or sweating duct |
| Swollen trim in rooms near a creek | Past flooding that was not fully dried |
Cost factors
National ranges from HomeGuide (2026) run about $500 to $1,500 for small areas of 10 to 100 square feet and $1,500 to $6,000 for 100 to 300 square feet; Greater Houston prices vary. Insulation removal, containment, built-ins and the consultant's separate fee all affect the total. A single closet wall behind a leaking water heater is a far smaller job than a band of drywall cut out of every downstairs room after creek water came in, and drywall, tape, paint and trim are often priced as a separate rebuild.
Mold in Walls & Drywall questions in Tomball
Do I need a permit to put the walls back?
What causes mold inside a wall when there was no flood?
My landlord has not fixed the leak behind a moldy wall. What can I do?
What happens if the wall fails the clearance check?
More mold services in Tomball
Mold in Walls & Drywall nearby
Sources
- EPA: Mold Cleanup in Your Home
- EPA: A Brief Guide to Mold, Moisture and Your Home
- TDLR: Mold Assessors and Remediators FAQs
- HomeGuide: How Much Does Mold Removal and Remediation Cost? (2026)
- Tex. Prop. Code 92.052: Landlord's Duty to Repair or Remedy
- City of Tomball: Floodplain Management
- City of Tomball: Building Permits
- City of Tomball: Building Division
- Community Impact: Tomball, Magnolia weather the storm, begin recovery
- Harris County Flood Control District: Spring Floods 2016
- Wikipedia: Tomball, Texas
Last updated: