AC and duct mold in Friendswood generally grows on the coil, in a drain pan that holds water, on attic ducts that sweat and around registers, and sometimes in systems that took Clear Creek floodwater. The fix is to stop the moisture and clean or replace the affected parts under a Texas protocol. Call the number on this page to be connected with a local mold remediation company in Friendswood.

Our home flooded in Harvey. Should we worry about the ducts?
It is worth checking if odors linger. Harvey's rains caused 500-year flood events along Clear Creek all through Friendswood, a preliminary estimate put about 3,000 Friendswood homes inundated, and the city issued 1,787 permits for Harvey repairs in 2017. In many of those homes, low returns, floor-level duct boots and closet air handlers sat in water. Equipment and ducts that were dried and reused can hold mold in places nobody sees, especially inside flex duct liners and insulation. EPA's disaster guidance says to assume mold where materials couldn't be dried within 24 to 48 hours.
We didn't flood. What causes mold in the system?
Everyday condensation. Friendswood's long cooling season keeps the evaporator coil wet for months, and a condensate line clogged with algae lets water stand in the pan. Ducts in a hot attic sweat if their insulation is torn or compressed, and supply grilles grow spots when indoor humidity stays high. Units that are too large for the house shut off before they've dried the air. Signs to watch include dark spots ringing ceiling vents, a sour smell in the first minute of cooling and water stains below the attic unit. Keeping indoor humidity below 60 percent and the drain line flowing are the habits EPA recommends.
How does the work go under Texas law?
A mold assessment consultant inspects and writes a protocol before anything is removed, listing the components, containment and clearance criteria. A separate company that holds a TDLR mold remediation license follows it, because Texas prohibits one company from both assessing and remediating the same project. A post-remediation assessment then checks the work, and you get a Certificate of Mold Damage Remediation, which a seller must share with buyers for five years.

A local note
Friendswood was founded as a Quaker colony in 1895 and lies in northwestern Galveston County, partly in Harris County, about 24 miles from Houston. Replacement ducts or equipment go through the city's Community Development Building Permits and Inspections, which issued repair permits after Harvey; ask your HVAC contractor whether a new air handler needs one. Renters can raise substandard conditions with Code Enforcement through its Submit a Concern form. The Galveston County Health District does not handle mold.
AC & Air Duct Mold Removal questions in Friendswood
Are the dark specks around my AC vents mold?
Does the mold company fix the air conditioner too?
What does AC and duct mold work cost near Friendswood?
Should the air in my ducts be tested?
More mold services in Friendswood
AC & Air Duct Mold Removal nearby
Helpful guides
Sources
- EPA: Homeowner's and Renter's Guide to Mold Cleanup After Disasters (pdf)
- EPA: A Brief Guide to Mold, Moisture and Your Home
- TDLR: Mold Assessors and Remediators FAQs
- TDLR: Texas Mold Assessors and Remediators Law
- 16 Tex. Admin. Code 78.150: Photographs; Certificate of Mold Damage Remediation; Duty of Property Owner
- Community Impact: Hurricane Harvey rains bring destruction to Pearland, Friendswood (2017)
- Galveston County Health District: File a Public Health Complaint
- Wikipedia: Friendswood, Texas
- City of Friendswood: Community Development
- City of Friendswood: Code Enforcement
Last updated: